boiler supplier

230 temp and 3 Mpa steam boiler

Conventional manner using a single heating boiler steam as the heat source, using a plate and then a change to a hot water using heat. Although this looked easy, but the second heat but lost a lot of heat. So fast boiler manufacturers recommend to everyone is: terms of heating, sanitary hot water, process water and other direct use of hot water boiler hot water, use a 230 temp and 3 mpa steam boiler where steam (food processing, hospital disinfection, chemical production, etc.) . Unless you can use a small amount of steam in the hot water usage to heat.

First Affiliated Hospital of Bengbu fully implement the national environmental protection policies, strict screening of clean boiler as the supply of medical supplies disinfection and ward heating equipment. Fast boiler with its focus on research and development of clean-type gas boiler two decades of experience in the industry favored. The partnership, to provide fast boiler First Affiliated Hospital of Bengbu Medical College, a WNS20-1.25-YQ one condensing 230 temp and 3 mpa steam boiler, in terms of design, manufacture, installation and other aspects of strict checks to enhance the thermal efficiency of the boiler as well as truly Energy saving and environmental protection.

In recent years, condensing boilers with energy-saving advantages to the market, into people's side. But there are a lot of people for saving condensing boilers can really skeptical. Fast boiler think, do not look at all the arguments of principle are pale. Today, we take a look, condensing boiler is how it works now.

Boiler commissioning sequence deviations four is what means: For boilers, in addition to those related to the previous knowledge of the contents, do I need to continue to learn to go? The problem, from the degree of learning has now reached a point of view, the answer is yes. So, then, without further ado, to proceed immediately to continue to study and work on the boiler, so we can learn a new harvest, and to make their own progress. 1. Cold and hot commissioning of the boiler, which is generally carried out first? On the boiler, cold and hot commissioning it, is necessary to carry out the work. For cold commissioning thereof, in general, under the boiler without heating, its debugging. And at the same time, see line valve leaks, electrical controls and the like are normal. And hot commissioning, debug is running the boiler at the time of heating, mainly for practical observation debugging parameters. Thus, to sum up, in the boiler, a first cold state debugger, and then the hot commissioning. If, cold debugging a problem, then that can not be hot commissioning, the problem must first be solved.

Related Information