quote natural gas boilers

The transformation of low nitrogen quote boilers should be noted that what matters for retrofitting low nitrogen boiler should be noted that what? Of nitrogen oxide emissions is large, complex sources, environmental problems caused by acid deposition, fine particles, ozone, nitrogen oxides and analysis of contamination status must be further strengthened. If you do not take further measures to reduce emissions, with the United States and the United States to speed up economic development, population growth and urbanization, nitrogen oxide emissions will continue to grow in China in the future. Based on current trends, by 2030, emissions will reach 35.4x106 tonnes, will inevitably cause serious environmental impacts. Therefore, we must effectively enhance the emission control of nitrogen oxides. From this we can see that low nitrogen boiler is imperative! A check device to check for low NOX combustion gas before commissioning is in place, the gas pipeline flow is clean, whether the valve is open. There is a burner pipe leaks, reasonable pipeline installation. Discharging vent pipe valve from the foregoing, to ensure that no mixing of the air duct, and the exhaust pipe should be connected to the outdoor. Second, stable combustion and combustion of homeostasis Remember, combustion adjustment is the basis for all of the low nitrogen burner adjustment, as long as guaranteed under any changes in operating conditions of combustion stability and combustion of dynamic equilibrium, to burn steam temperature influence is even greater. Since the steam temperature is a sign flue gas heat value balance between the steam and heat absorption, this can be maintained as long as the dynamic balance, steam temperature can be kept stable. Third, the level of flame boiler boiler central flame center is also an important factor in high impact low-temperature steam. In the high temperature steam operation, the amount of coal combustor exhaust can be reduced, the amount of the lower stage burner of coal may be increased, and vice versa. Running low nitrogen burners, it should also be noted effect of different combinations of temperature steam mill. Steam at a low temperature exhaust composition regulating a large margin, the combination of the high temperature exhaust temperature adjusting stage so small margin overheat. It should be strengthened and soot blowing air distribution according to the situation.

It provides fast side of quote boilers equipment, installation and commissioning after all normal, we immediately put into use, the hotel did not delay the normal heating. Meanwhile boiler capacity, energy efficient, fully able to meet the needs of heating and bathing water in our hotel rooms. --customer feedback

What is the difference between a gas-fired quote boilers and a coal-fired boiler?

Both gas and coal can be used as fuel for boilers, but different types of boilers are named according to the types of fuels used, so there are gas boilers and gas boilers. So what is the difference between a coal-fired boiler and a gas-fired boiler, apart from the fuel used in combustion?

1. The fuel used by different coal-fired boilers to exhaust smoke is coal. When coal burns, it will cause serious pollution to the environment by producing larger smoke and dust. However, high-stability gas-fired boilers do not emit black smoke after combustion. Because gas can basically be completely burned, smoke-emitting black poison can reach zero level, the content of SO2 in it is very small, so there is no pollution to the environment.

2, heat loss is different in order for coal-fired boilers to maintain adequate combustion intensity, the use of human or other equipment to constantly add coal to the furnace, when the need for intermittent operation, It takes a long time to raise the temperature in the furnace when starting again, so it will produce great heat loss when pressing fire, and the gas-fired boiler is very convenient to start and stop, and can heat up rapidly during intermittent operation, so as to reduce the heat loss in this process.

3, the different ways of treatment after combustion will produce a large amount of ash after burning in the boiler. In order to maintain the health of the environment, the ash will be transported to the professional slag removal yard for treatment, but gas is used in the gas-fired boiler. There will be no residue after combustion, so there is no need to deal with it. It not only avoids the pollution to the environment, but also reduces the labor intensity of enterprises and the storage and transportation of urban ash.

The arches of DHL Series Corner Tube Chain Grate Boiler can be redesigned according to the specification of the coal.

Reasonable requirements with the wind, it will cause the boiler coking. The ratio between each segment for the amount of wind, we need to determine good or bad based on coal quality, coal seam thickness on the grate, flue gas oxygen content, CO content, load size and other factors. For different loads and different combustion air in case of need to be summarized based on the ratio of long practical experience, the formation of a set of data in order to guide the operator to ensure the safety of energy-saving boiler operation.